Description

Coming Soon

ATS – Automatic Transfer Switch
The PY000A000C1 automatic ATS panel for power generator allows you to connect the generator set to the home network so as to allow automatic start-up in the event of a power cut. Pramac ATS PY000A000C1 is used to transfer the electrical load from a main source (mains) to an emergency power source (generator). When the main power source goes out, the ATS allows the generator to provide electrical power to connected electrical loads.
Mode selector
If the primary energy source stops providing energy, the Pramac ATS automatically starts the generator. After approximately 1 minute the ATS supplies power to the generator’s electrical load. If the main energy source is restored, after approximately 1 minute the ATS stops the generator.
Emergency button
The emergency stop button allows you to immediately stop the generator and stop the battery charging function.
Warning lights
Present are the mains power indicator lights, generator indicator light, load indicator light, battery indicator light and fault indicator light. With ATS multipin connector and signal cable.
Technical data

• Exercise voltage: 8 – 15V DC
• Rated Current Single Phase Meter: 45 A (80 A Version Out Soon)
• Rated Voltage Single Phase Contactor: 230V
• Nominal Frequency: 50Hz
• Nominal power: 10.35 kVA
• Charger Output Voltage: 13.8V DC
• Charging Current: 1 A
• Operating Temp. Interval: -20°C ÷ 70°C
• Entry Protection: IP 20
• Cable: 5 m
• Dimensions: 32 x 25 x 14 cm
• Weight: 5kg